Decking Installation
Instant decking in just few simple steps
Pre-drill and fasten outer edge of the first plank at each framing support 1” from the edge using stainless steel finished nails or ENiTo decking screws. Position ENiTo decking Clip.
Fully insert the ENiTo decking clip into grooved edge of the board. Install the ENiTo decking clip with screw into the joist. Make sure the clip is in full contact with the board and the screw is holding the clip tight to the deck board. Screw should be installed in the center of the joist.
Place the next board into position against the clip. Slightly raise the outer edge of the board being installed and slide it into the clip until the plank contacts the spacer. Pound it tight with a non-marring hammer then repeat steps through for the remaining boards. Pre-drill and install the last deck board as described at step 1.
